This item may not be in stock; please email service toolsource.

Removes transmission extension housing bushing. The tool is inserted through the bushing and the drive fall foilage trees southwest is tightened to draw the bushing out of the housing.

Related Products.

" ID with" OD at the pulling teeth. Similar to Applications include Ford Ranger transmissions: 4R44E/5R44E; 5R55E; A4LD; C3; T5OD; 6F35; 6F15Missing: tailshaft. Feb 14, Replace without Housing Removal; Easy How To Replace Automatic Transmission Extension Housing Tailshaft Bush Bushing & Seal; DIY Replace Automatic Transmis. Used this tool to pull and replace the tailshaft bushings in both my '84 Mustang with the T-5 and my '57 Thunderbird with the Fordomatic.

Tool works excellent. Make sure to grease the threads on the puller and go slow with hand tools only. Both bushings pulled right out with no issues. Driver tool put the new ones back in square and easy/5(12). Dec 11, Trophy Points: Location: Opelousas La. It's just as easy to remove the tailshaft housing from the transmission and remove the bushing standing up, instead of laying under the car. Last one I did, all I used was a screw driver and hammer to remove it, once it was out of the car.

Come think of it, I don't see how either of those tools. Jul 05, The combination set is T Here is a link to the original catalog: Tools_Kit_stumplopping.bar The 20 piece set sells foron ebay. Here is the link: SST Transmission Bushing Driver Kit. Does anyone know if this set contains drivers that will be useful for a C4?

Jul 23, You don't even need to pull the tailshaft housing. There's a special puller to remove the bushing - buy or rent one, or just have your trans shop do it for you.

Remove the driveshaft. Remove the oil seal, remove the bushing, drive in a new bushing.

Part number works with transmissions that have the short selector shaft.

May 03, Bushing Pullers. Jaws are inserted through the grease seal and between the bushing and shaft. Sliding tube secures jaw grip behind bushing. Turn screw with wrench to remove bushing seal. Bushing Drivers. Handle screws onto one end; bushing is placed on the other end and driven into shaft housing with a few light hammer blows.

Oil Seal Installers. This tool was designed to gain access for removal and replacement of the shift selector shaft seal on G.M. rear wheel drive transmissions.

Part number works with transmissions that have the neutral safety switch around the transmission shift selector which requires a Missing: tailshaft.