NOTE: Be sure to take into account any slopes in the fall zone.

Feb 11, To start the cross cutting chainsaw technique, cut about 1/3 of the way into the log from the top. Next, use the underbucking technique to cut into the log from the underside and cut upward until you reach the first cut.

As you get closer to the top cut, the weight of the wood should cause the log to split in half and fall downward. The HADDON LUMBERMAKER is a chain saw accessory that allows you to make your own valuable lumber for a fraction of the regular cost! It attaches to any chain saw in minutes and guides your saw in a straight line using a guide board, 2x4 or 2x6, allowing you to cut any size lumber right where the tree /5. Aug 27, A drunk uncle beheaded his sleeping nephew with a chainsaw and then claimed he was dreaming of cutting a coconut tree, say police.

Roger Paje, 48, is accused of cutting off Estimated Reading Time: 2 mins. Jun 21, A Humboldt cut is a three-step process for cutting down a tree (or part of a tree). First cut into the trunk just above the highest branch you want to retain. Place the chainsaw against the side of the tree toward which you want the top to fall. Make a horizontal cut into the tree. Stop cutting when you're about 1/4 to 1/3 of the way through the tree's stumplopping.bar: 31K. Aug 01, On larger trees, turn off the chainsaw partway through the cut, remove it from the tree, and drive wood or plastic wedges into the cut to keep it open.

Restart the chainsaw and carefully put it back in the cut, being careful not to do any cutting with the tip- cuts along the tip can cause the chainsaw to kick back at you. The tree starts falling before you've cut all the way through, with the uncut section acting as a hinge that slows the fall and controls its direction.

As soon as the tree. Dec 29, Your first cut should be straight down to the halfway point. Remove your guide bar from the tree trunk, turn off your chainsaw and place a wedge into the top of the cut to prevent the chain from binding. Start your chainsaw and while idling, slide your guide bar into the cut. Remember, the wedge is. MAXTRA Gas Pole Saw, CC 2-Cycle Powerful Chainsaw Reach to 15 Foot Extendable Cordless Gas Long Reach Tree Trimmer Pruning Chain Saw with Portable Bag out of.

Aug 18, Step 3: Measure and Mark the Tree Log. When you cut wood slices with a chainsaw, the thickness of those slices are up to you. You can choose 1″ inch slices, 2″ slices, 5″ slices, more. No matter what thickness you choose for each slice, the same step applies: measure the thickness with a tape measure and put a marking all around the tree log.

Dec 21, Once you have felled a tree, you must cut 10 ft north valley spruce tree with clear lights up by removing branches and cutting segments into pieces of a manageable size. Here are some tips for how to limb a tree using a chainsaw. The main thing you want to avoid when limbing or crosscutting a tree using a chainsaw is kick back, the upward and backward motion that happens when the top of the chainsaw bar nose.