Transport width 1, mm 75 in.

Posted by TerryMi on October 01, at from: What is the trick to removeing the stump jumper on a bush hog? I need to remove it, so I can tighten the bolts holding the gear box.

MX7 Rotary Cutter.

Sep 29, Posted: Fri Sep 27, pm Post subject: Re: Bush Hog Stump Jumper Removal: Worked on a 6 ft bushhog"squealer" once had to take the bolts out that held the knives on (big hammer). Then the pan came right off, but to get the big piece of solid bar off that splines to the gear box and that the knife bolts go through I had to wrap a chain around it and around a big bottle jack with the.

I have removed the nut that holds it on but can not move it at all. There must be a trick to it. I have to remove mine so I can tighten the bolts that hold the gear box.

Thanks Terry.

Front and rear safety chain shields are standard Front safety chains MX6 shown.

Follow Ups: Re: How to remove stump jumper on bush hog jimmy69 10/02/05 (0). May 17, Use wd40 and wedges between mower housing and stump jumper. loosen the castle nut untill you have 1/4" under it and the seat. Then hit the nut to. May 02, Lay out the center of the stump jumper and then drill and tap a 3/4 inch fine thread hole and wind a grade 8 bolt in and maybe it will free the stump jumper.

The hole must go through the stump jumper so the bolt pushes on the gearbox stumplopping.barted Reading Time: 4 mins.