Leave a reply.

May 31, Finding the sway bar and ensuring the bushing doesn’t have any tear and is performing in perfect condition is exceptionally stump removal fayetteville nc. Go further by moving the sway bar, and if you are feeling any movement, then it has deteriorated. Also, inspect if it has any worn-out stumplopping.barted Reading Time: 7 mins. Begin the reinstallation of the sway bar bushing by spraying some multi-purpose silicone lubricant on the sway bar to help the new bushing slide into place.

Open up the split edge of the bushing and install it onto the bar (make sure the orientation of the bushing is correct.

Jul 02, Jun 8, #1. I was wondering if anyone has a picture of the front sway bar bushing and if there is any gap from the bushing to the bar. There is a pretty big gap"from what I would consider" on my front bushing the rear is a perfect tight no gap fit. The bushings that used to be there were 34mm the replacement moogs are the same size.

Jan 04, Tip: If you’re forced to drive with a broken sway bar, you need to drive slower than normal. Try to stick to surface streets and stay off highways and interstates where you might be required to change lanes. As long as you keep your speed down and don’t take turns too quickly, you should be safe driving until you can have it replaced. Note that a broken sway bar doesn’t make your car “un.

Aug 21, Ditch the rear and you will get more out of the rear than with it on. The shock is now the limiting factor and not the sway bar. Will handle like sh!t on. Dec 24, It could affect the ride slightly, but I doubt that you feel it unless the bushings were completely worn out. You would also probably have the feeling of slop from side to side more than anything. I removed my sway bar years ago and threw it in the trash.

Aug 17, There is a drop link that attaches the sway bar to the strut. You will need to remove the lower link from where it attaches to the sway bar by holding the large nut with a 16mm wrench and turning the smaller inner bolt with a 7mm and push the link out of the sway bar.